4 washers (grade 8, a little less than 1/8th eachI thought the hump between the mounting bolts would cause clearance problems? How thick is your washer stack? Thanks for the pic!
Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.
If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.
Enjoy.
4 washers (grade 8, a little less than 1/8th eachI thought the hump between the mounting bolts would cause clearance problems? How thick is your washer stack? Thanks for the pic!
1.5" longer than Mustang II standard. Taper is 7 degrees, Alpine is 6.5 degrees, so steering arm would need reamed out slightly.
I installed a mustang II rack with 2” drop Wilwood mustang II spindles, five bolt ford pattern 11” ventilated discs. Had to ream out the spindles to match the sunbeam ball joint taper upper and lower. Running 15x7 rims up front and 15x8 rear on ford discs as well. Rear is also dropped 2”.
I installed a mustang II rack with 2” drop Wilwood mustang II spindles, five bolt ford pattern 11” ventilated discs. Had to ream out the spindles to match the sunbeam ball joint taper upper and lower. Running 15x7 rims up front and 15x8 rear on ford discs as well. Rear is also dropped 2”.