• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Search results

  1. C

    Door strike plate

    I can't seem to tighten the door strike plate on my Alpine 5 . The doors are about 1/8 inch out of flush. The tightening screws are hard to turn and the plate slides out when the doors are closing. Before I tear into it, are there backing nuts inside the body and are they accessible? Clark
  2. C

    Speedometer gear

    The gear in the transmission has been stripped on my 66 series V. I can rotate the rear wheels and feel a rubbing on the drive gear which is in good shape. Looking at all the diagrams I can't tell if this internal gear is part of the shaft or is separate from it. Repair procedure anyone? Can...
  3. C

    Overdrive

    Thinking of putting an overdrive transmission in My series V. Is there any problem fitting an earlier series transmission? I believe they are all non-synchro, or is synchro on some earlier models? Anyone know sources other than ebay?
  4. C

    New Engine

    Put a new short block in my V. Did all the usual, new guides, valve seals, some new valves, etc. Castrol 10-30, ZDDP. Ran around town,, up and down for 1/2 hour, changed oil and filter. Have since run about 400 miles. Varied driving as I live in a rural area. Car runs like a dream. On start up...
  5. C

    Flushing oil

    Finished installing new short block on my series V and car is running great. Looking at the utube on rebuilding, they used flushing oil after the initial break in. I changed oil after 1/2 hour and now have about 500 miles on her. Is it a good idea flushing before changing to the Rotella T6 I...
  6. C

    Tachometer reading too high

    Driving my Alpine V today and tachometer jumped from about 3000 to over 6000. Now reads very high at any RPM, Ideas for fixing? Clark
  7. C

    Distributor timing

    Just finished installation of a new block in my 66 Alpine and all went well. Set the timing using the light bulb method. Find now I must have done something wrong as the timing is off. Looking for suggestions on how to see the timing marks. Have tried a mirror find it difficult to see what is...
  8. C

    Valve lifters

    Rebuilding my Alpine. Got a new short block from Sunbeam Specialties, cam done by Delta and new lifters. All back together, tried to get lifters in. Would not go. Tried to wash out bores with MEK on a rag and re-lubricated with assembly lube. Barely able to get seven in and they are very...
  9. C

    TDC on 1725

    Am rebuilding my 66 Alpine. Haynes manual says TDC on compression stroke is when dots on timing gears are aligned. Several posts say to rotate 360 degrees from dots in line to get compression stroke to install oil pump. Which is correct?
  10. C

    Speedo gears

    I have a 66 Alpine. Speedo does not work. Cable is but does not turn. Took the gear out of the transmission and looks ok. What do I need to take apart to check the inside gear? Can't find reference to the inside gear and how attached. Know where I can find one?
Top