Ring and Pinion 19 spline source??????

[Mikeflbmer]

.(changing gears) cant seem to find a source of a NEW ring and pinion for a ( 19 SPLINE.....ones I find are a differnt spline (DOES THAT MATTER?).............i am getting a posi installed and need a lower gear than 288,,,,have a used 3;23 but the shop will only install a new gear set....ANY SOURCES???

 

[260Alpine]

Mike, ring and pinion are the same except you have 19 spline axles and most newer have 30 spline axles. That difference is in the differential side gears.

 

[260Alpine]

If you aren't interested in originality the 72-75 Jeep CJ5 and Postal have 30 spline flanged axles that are much stronger than the Tiger 19 spline axle with separate hub.

 

[260Alpine]

Here is one example:

High performance Yukon Ring & Pinion replacement gear set for Dana 44 in a 3.31 ratio | YG D44-331 | RANDYS Worldwide

Yukon Gear & Axle high performance ring & pinions set the standard for quality. Yukon designed the gear tooth surface finish to reduce friction and heat, and use high grade steel in both the ring & pinion, with fitment designed to OEM spec

www.randysworldwide.com

 

[Mikeflbmer]

If you aren't interested in originality the 72-75 Jeep CJ5 and Postal have 30 spline flanged axles that are much stronger than the Tiger 19 spline axle with separate hub.

Are the lenght of these axles same as tiger? a drop in?

 

[260Alpine]

Pretty close. Most are 3.73 some are 3.07. Spring perches need changed and axle flanges need to be redrilled.

 

[260Alpine]

Posts 410 and 411 on this thread:

Now I'm in for it.

I know I am all over the place, but today I installed the 3 point seat belts. I had bungs welded into the roll bar for a high mounting point. I used the regular seat belt mounting points with new hardware for the belt anchors and I mounted the retractor to the base of the roll bar with heavy...

forum.sunbeamalpine.org