My series V original heater control valve finally gave out. I installed an MGC heater control valve, as it is similar looking to the original Alpine heater control valve. During the install, the plastic (?) hose connection point separated from the valve body. It appears the hose connection was just glued in.
Have other folks had this issue with these valves? Anyone figure out a glue that will work or another option for the hose connection?
Obviously, I can return the valve for a refund, but that doesn't get me a working valve.
Thanks,
Mike
Have other folks had this issue with these valves? Anyone figure out a glue that will work or another option for the hose connection?
Obviously, I can return the valve for a refund, but that doesn't get me a working valve.
Thanks,
Mike