SV Parts

[blownhorse]

I am changing directions in my hobby efforts and have the following SV Alpine parts for sale:

hood, hinges, latch assembly
decklid, hinges, latch assembly, spring support linkages
convt bows
convt top body chrome end caps
radiator
rear brake drums, backing plates, cylinders, clips, park brake linkage, etc
front brake rotors, calipers, spindles (complete)
horns
steel wheels, hub caps
front bumper, brackets, bumperettes
side window (driver side)
quarter window and frame (pr)
door window linkage, crank mechanicsm, handles
door latch linkage, plates, handles, pulls, recievers
heater core
heater controls, face plate, cables
shifter tunnel cover
driveshaft
gauges
instrument panel
panel switches, lights, ing. sw
glove box frame
lower dash frame
gas tanks, cross-over tubes, clamps
transmission crossmember, mount
rear axle shaft, bearing (1 only)
rear end 3rd member (3.89 open)
headlight buckets, trim ring (no brow), headlight mount rings/cups
taillight housing, chrome (1 only)
bellhousing, throwout bearing, fork
transmission
engine (with front mount, dist., valve cover)
water pump, fan, pulley
engine upper water reservoir
alternator with mounting brackets
flywheel (8.5" disc)
oil cooler setup (complete; hoses, cooler, engine adapters)
starter
exhaust manifold
dual carb setup (complete; carbs, manifold, linkage, air cleaners)

I have just finished disassembling this very late SV car. I have kept track of most all hardware for these pieces. Please contact me at blownhorse@msn.com or PM here for additional details and photos.

Thanks, Jim

 

[afc742]

hub caps

Are the hub caps in good condition?

 

[blownhorse]

Let me take a close look at them tomorrow and report back. I will post pictures. Thanks, Jim

 

[whoizrob]

Possibly interested in the alternator and the Speedo. I am looking to convert to neg ground and would prefer a plug and play solution. Thanks!

Rob

 

[ALPINE5GT]

I am interested in the conv top bows, and the oil cooler assy, as the SV I bought has neither.
Can you send me a price and pix?
Thanx, Kevin
nmcb18atgmaildotcom

 

[blownhorse]

Hub Caps

Thanks for the responses.

I have attached photos of the hub caps for AFC742. All are in very serviceable condition. I tried to show where one hubcap has a little wave in it around the center face and toward a cutout. Pretty minor, but wanted to identify it. One other hub cap has a little tip of cut out flange sticking up. Should be easy fix with tap of hammer. Other two are really nice. Asking $20 for set. I can send additional pictures if you like. Thanks, Jim

 

[blownhorse]

Alternator and Speedo

Thanks for the responses.

I have attached photos of the alternator, brackets, and speedo for Whoizrob. Since you are looking at an alternator conversion, I wanted to include the regulator as well. The car had been sitting for 20 years and the charging system was working at that time. Hopefully, they still work now. Alternator does spin freely and I have bagged all mounting hardware. Would like to get $40 for everything.

I have attached photos of the speedometer. It looks to be in serviceable condion. It does have some surface rust spots on the back as shown. The face and trim look nice. Mounting studs are in place. I attached a speedo cable and turned it to confirm operation. Would like to get $30 for the speedometer. Another $10 for the cable and it also is in serviceable condition.

Please contact me at blownhorse@msn.com for additional info or pictures. Thanks, Jim

 

[blownhorse]

Conv Top Bows & Oil Cooler Setup

Hi Alpine5GT,

Thanks Kevin for the inquiry on the conv top bows and oil cooler setup. I have sent you an email with pictures, description, and prices.

Thanks,

Jim