Alpine sat for about a month, I went to drive it last week and the clutch pedal went to the floor. It was visibly leaking at the firewall just like the brakes were before I rebuilt them.
I ordered a rebuild kit from SS and installed it this week, no change. I pulled the bleeder valve from the slave cylinder, plugged it in to the master cylinder and looped a hose back to the reservoir and it shot all of the air out after a few pumps and when the bleeder is closed the pedal won't move.
I hooked everything back up and bled it both with a vacuum pump and by pressing the pedal and opening the valve and there wasn't really any change. The pedal goes to the floor. The rod out of the slave cylinder moves a little bit sometimes, but most of the time it stays still.
Does this sound like a failed slave cylinder? I rebuilt it a few months ago but the master was visibly leaking before the rebuild and there isn't any fluid leaking out of the slave cylinder so I'm skeptical that both failed at the same time.
I ordered a rebuild kit from SS and installed it this week, no change. I pulled the bleeder valve from the slave cylinder, plugged it in to the master cylinder and looped a hose back to the reservoir and it shot all of the air out after a few pumps and when the bleeder is closed the pedal won't move.
I hooked everything back up and bled it both with a vacuum pump and by pressing the pedal and opening the valve and there wasn't really any change. The pedal goes to the floor. The rod out of the slave cylinder moves a little bit sometimes, but most of the time it stays still.
Does this sound like a failed slave cylinder? I rebuilt it a few months ago but the master was visibly leaking before the rebuild and there isn't any fluid leaking out of the slave cylinder so I'm skeptical that both failed at the same time.