• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Series I, II fuel sender question

T

Tom H

Platinum Level Sponsor
I'm trying to repair a SI,II fuel sender for a friend. The lead wire to the wirewound resistor is broken and I cannot tell which end of the resistor is was originally connected to. Can anyone share a photo or direct me to a photo of the inside of one of these early senders. And can anyone share a photo or drawing that would show how / where the sender is mounted on the tank.

Tanks :rolleyes:

Tom
 
T

Tom H

Platinum Level Sponsor
Never mind! I found the dwg for how it's installed in the Parts manual. Turns out it's not an SI,II sender, but a SIV sender.
 
You must log in or register to reply here.
Top