I posted this last week in the "Stock" Alpine Forum but no one was intersted. So I thought I'd try this one.... The hex stock has arrived today. I can get up to 16 of these nuts made with a 1 foot long piece of stock.
Hello all,
I've been having trouble finding a new nut that goes on the front end of the transmission primary (output) shaft (Alpine Series IV B9400037). I decided to have it made by a local machine shop. The nut is 1-5/16" hex and 1" inside diameter with 20 threads per inch UNF. The nut material will be hex cold finished stock 12L14 which is slightly harder than the original nut material which is probably 1218 stock.
Does anyone else want one or more of these nuts? I am going to have at least 10 made (maybe more). The cost to make 5 nuts is about the same as making 1 nut due to the machine shop set-up for the production.
If I make 10 nuts my cost per nut is going to be roughly $26.80 per nut.
If I make 16 nuts my cost per nut is going to be roughly $21.29 per nut.
If there is interest, I will have a bunch of these nuts made up.
Our contact info can worked out later.
Chasedan
Hello all,
I've been having trouble finding a new nut that goes on the front end of the transmission primary (output) shaft (Alpine Series IV B9400037). I decided to have it made by a local machine shop. The nut is 1-5/16" hex and 1" inside diameter with 20 threads per inch UNF. The nut material will be hex cold finished stock 12L14 which is slightly harder than the original nut material which is probably 1218 stock.
Does anyone else want one or more of these nuts? I am going to have at least 10 made (maybe more). The cost to make 5 nuts is about the same as making 1 nut due to the machine shop set-up for the production.
If I make 10 nuts my cost per nut is going to be roughly $26.80 per nut.
If I make 16 nuts my cost per nut is going to be roughly $21.29 per nut.
If there is interest, I will have a bunch of these nuts made up.
Our contact info can worked out later.
Chasedan