Front valance needed for Series II

[T.Jack]

Hi,
I am in need of a front valance for a Alpine Series II. I'm located in the Seattle area. Thank you.

Todd

 

[PawPaw]

Just found this on Moss motors site. It's pricey.

 

[Barry]

With today's hourly rates at a good body shop, it might (if it fits) be a bargain compared to repairing a damaged lower front valence.

It would be interesting to know the source of the replacement panels that Moss is selling.

https://mossmotors.com/sat-001-sunbeam-body-panels-for-alpine-tiger

 

[alpine_64]

With today's hourly rates at a good body shop, it might (if it fits) be a bargain compared to repairing a damaged lower front valence.

It would be interesting to know the source of the replacement panels that Moss is selling.

https://mossmotors.com/sat-001-sunbeam-body-panels-for-alpine-tiger

I think they are the ex VB ones... Iirc they were a much heavier gauge steel and can take a fair bit of work to fit right

 

[T.Jack]

Thank you all for your help, I really appreciate it!!

 

[T.Jack]

A quick question for everyone… the valance at Moss says it’s for a series 4 & 5. Will it fit my series 2, or will I need make adjustments? Thanks again!!

 

[PawPaw]

I think it will. There are more experience people on this forum.

 

[PawPaw]

https://sunbeam-alpine.co.uk/files/Alpine and Tiger Catalogue.pdf
according to these folks one size fits all. series 1 - 5 plus tiger

 

[T.Jack]

https://sunbeam-alpine.co.uk/files/Alpine and Tiger Catalogue.pdf
according to these folks one size fits all. series 1 - 5 plus tiger

thank you!!