• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Front Hub Grease Seal Installation

Steeman01

Steeman01

Donation Time
I'm in the process of rebuilding my front brakes and hubs and I greased the bearings and I was about to install the grease seal on the back. I see that the manual says to "press" it in place, would it suffice if I used a soft block of wood and a mallet to slowly work it in? Thoughts or suggestions are welcome! Thanks! SP
 
Gordon Holsinger

Gordon Holsinger

Diamond Level Sponsor
Steeman01 said:
I'm in the process of rebuilding my front brakes and hubs and I greased the bearings and I was about to install the grease seal on the back. I see that the manual says to "press" it in place, would it suffice if I used a soft block of wood and a mallet to slowly work it in? Thoughts or suggestions are welcome! Thanks! SP
Click to expand...
A block of wood is fine!
 
You must log in or register to reply here.
Top