• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Engine Torque specs

J

jzuk7

Donation Time
I am reassembling my 2.8 v6. What should I torque the main and rod bearing too? The engine is a 85 ranger v6. I think the manual for a mustang II says rods should be set around 25 ft/lbs and the mains around 65 ft/lbs. This sound correct?

Thanks,

Joe
 
J

jzuk7

Donation Time
Jim,

Thanks for the information. That is exactly what I was looking for.

I still have a lot of work to do before I'm ready to install the engine. How are the conversion kits coming? I feel like a kid anticipating Christmas!:)



Thanks,

Joe
 
Rsgwynn1

Rsgwynn1

Silver Level Sponsor
I notice from the pictures in the link that the timing mark alignment seems to be about one click counter-clockwise. Any way to measure this exactly before reinstalling the camshaft and gear?
 
You must log in or register to reply here.
Top