Ron67Alpine
Silver Level Sponsor
I may have located the problem. Chuck Ingram, suggested on another thread that the problem may be w/the distributor bushing. Based on that suggestion, the timing "bounce" and pulling the distributor was the easiest thing to do, I pulled the distributor. I discovered a good size crack, in the casing, right where the flange clamp goes around the distributor shaft housing. So, would I be correct, that this kind of damage is not repairable, and the distributor should be replaced, even if it's not the cause of the squeal?
Can anyone recomend an inexpensive replacement? I know the "Flame Thrower" IE distributor is around $200 and seems to be readiliy available.
Tom, is the inspection plate connected back to the oil pan by those 2 bars?
Ron
Can anyone recomend an inexpensive replacement? I know the "Flame Thrower" IE distributor is around $200 and seems to be readiliy available.
Tom, is the inspection plate connected back to the oil pan by those 2 bars?
Ron