SeriesVtime
Donation Time
I'm seriously looking into moving away from the stock ignition system and to using an electronic trigger wheel but wanted to get some thoughts on where best to place the trigger wheel. There are two possibilities: in front of the harmonic balancer or behind it.
My preference is behind it, but my motor is out at the machine shop so I can't measure and assess whether there's adequate room to bolt a 1/4" thick plate with 36 teeth to the back of it and still clear the timing chain cover, and anything else that might be back there. I recall there's a standoff that comes through the cover and requires a nut to secure it, but I don't recall whether that's within the circumference of the pull, or not.
Thoughts? Thanks!
My preference is behind it, but my motor is out at the machine shop so I can't measure and assess whether there's adequate room to bolt a 1/4" thick plate with 36 teeth to the back of it and still clear the timing chain cover, and anything else that might be back there. I recall there's a standoff that comes through the cover and requires a nut to secure it, but I don't recall whether that's within the circumference of the pull, or not.
Thoughts? Thanks!