Mike Armstrong
Bronze Level Sponsor
This is the ignition coil recommend by The Ranger Station in they’re Duraspark II Conversion article.
https://www.napaonline.com/en/p/MPEIC21SB
http://www.therangerstation.com/how-to/ignition-charging-computers/2-8l-duraspark-conversion/
I noticed on the front of it is written ‘Use with Electronic Ignition’ (ie Duraspark II, I assume).
1) What type of proper electrical connector is supposed to be used on those terminals? Or do you simple wrap exposed wires around the posts?
2) Does this coil require an external ballast resistor?
This is the stock 1985 Bronco II coil I’m currently using, with an external ballast resistor.
https://www.autozone.com/ignition-t...ignition-coil/duralast-ignition-coil/112052_0
I can’t find the output specs on either coil.
1) Is this stock coil any better/worse than the one above?
https://www.napaonline.com/en/p/MPEIC21SB
http://www.therangerstation.com/how-to/ignition-charging-computers/2-8l-duraspark-conversion/
I noticed on the front of it is written ‘Use with Electronic Ignition’ (ie Duraspark II, I assume).
1) What type of proper electrical connector is supposed to be used on those terminals? Or do you simple wrap exposed wires around the posts?
2) Does this coil require an external ballast resistor?
This is the stock 1985 Bronco II coil I’m currently using, with an external ballast resistor.
https://www.autozone.com/ignition-t...ignition-coil/duralast-ignition-coil/112052_0
I can’t find the output specs on either coil.
1) Is this stock coil any better/worse than the one above?