weaselkeeper
Silver Level Sponsor
A question for those who have gone before. I installed the v-6 w/ Jose kit today for the mockup of hoses and build of new fuel/brake/clutch lines. I also bolted up the headers. My headers come off the engine and take a turn of 30 - 45 degrees outboard, rather than running relatively straight back. From the header flange, I have little room to make a tight turn back to the center of the car to use the exhaust pass throughs (2) at the xmember, beside the d-shaft tunnel. The way the header flange is placed, it would be set up great for side pipes. Is this the normal way these headers turn out?
Maybe one of you has a pic of your headers from the bottom side? Thanks for input.
Maybe one of you has a pic of your headers from the bottom side? Thanks for input.