• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Stock fuel pump rebuild

G

glassman

Bronze Level Sponsor
Valves are slightly punched to hold in. Would I lightly scrape with blade @ recess to pick out of pocket. Hate to ruin , any one dealt with I'll take advice. Thanks Glassman
 
Mike O'D

Mike O'D

Gold Level Sponsor
I used a rounded tip punch to tap the material back into shape so the valves could be removed.
 
G

glassman

Bronze Level Sponsor
Thanks Mike so tap the 8-9 impressions a little from edge to pull metal from recess then maybe flat tamp down to hold? Thanks again
 
Mike O'D

Mike O'D

Gold Level Sponsor
I think I used an automatic center punch in a few places around the edge to lock the new valves in.
 
You must log in or register to reply here.
Top