• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Search results

  1. Q

    Fender Motif & rubber hood spacers reattachment

    Hello Restorers- I finally found replacement motif badges and surrounds, but I can't figure how to get behind the front fenders to reattach them to the car. Forum search for "Motif" described how to remove & refurbish, but I failed to find how to re-attach. I'm worried there is no access to...
  2. Q

    Stromberg 150 float bowl o-ring

    I can't locate a size for the float bowl seal o-ring nor the mixture adjusting screw o-ring. Forum threads note Ace Hardware (plumbing?) nitrile o-rings may work. Carburetor sites state Viton o-rings are the correct fuel resistant material. Does anyone know the size and material information...
  3. Q

    Stromberg gas leak repair-fail; seeking advise

    After updating fluids, hoses, fuel filter, timing chain cover and tensioner on "Q", sV mostly stock alpine which was running well, we noticed the Stromberg carbs leaking at the bottom. After searching the forum and consulting the WSM, we unscrewed the bushing and replaced the o-rings with...
  4. Q

    Hello from New Member "Q"

    Hello Folks, Thanks to Tom Norby for setting up my account. I'm looking forward to a fun, educational relationship with this forum and club. My first car circa 1975 was a carnival red Sunbeam Alpine, likely a series III or IV. It came with a stripped down parts car, both for $400...
Top