• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Wanted: bad 1592 oil pump

sunbeam74

sunbeam74

Silver Level Sponsor
I am looking for an oil pump from a 1592 engine. Distributor drive pinion must be good and have oil line to block. Condition of the actual stator and rotor not important.

Thanks,

Steve
milano164@comcast.net
 
R

RootesRacer

Donation Time
alpine_64 said:
MG oil pump mod?
Click to expand...

That might be excessive for a 1592, a 1725 gerotor set would probably be just right.

BTW, I spun a 1725 gerotor set on my lathe a while back to see if they can be shortened (for a 1592) and the good news is that they can.

The bad news is that they are cast iron and make an awful mess of iron powder.
 
You must log in or register to reply here.
Top