S2 Windshield vertical alignment.

[jmahall]

Installing windshield soon. I seem to recall somewhere here about using rubber wedges to get the right angle between the windshield A pillar and the side door glass guide to line up parallel.
Any advice here as to what to use and how to install?

Thanks

 

[Alpine Addict]

I believe Rick at Sunbeam Specialties may have some adjusters

 

[sunalp]

DanR has them too!

 

[absunbeam]

On the CAT site, windshield installation was just covered. Had an issue with getting the lower windscreen rubber to sit flat in the middle of the body.
Marty (KettleCarver)had a set of adjuster from Rick, had to turn down the OD of a 3/8”size, 1/4” drive deep well socket to 1/2” to align the adjuster on the corner. There are instructions that come with the adjusters.

 

[Toyanvil]

I just used flat shims, I made out of thin aluminum.

 

[jmahall]

I ended up using a combination of rubber washers and plastic wedges.

Thanks for the input.