puff4
Platinum Level Sponsor
Yesterday, in disassembling my rear axle to R&R it, I noticed that my emergency hand-brake crossbar has a bend in it. I cannot recall if this bar was straight or has always had this bend, and I have no other bar to compare it with. I also looked in the parts book and could not find this illustrated.
My question is, should this bar be straight or should it, indeed, have this light bend in it?
The bend can be seen in this photo, to the right side, near where the bar goes through the guide bracket. It is an arching bend.
My question is, should this bar be straight or should it, indeed, have this light bend in it?
The bend can be seen in this photo, to the right side, near where the bar goes through the guide bracket. It is an arching bend.