Mustang 2 oil pan

[socorob]

Is the Mustang II oil pan a front sump?

 

[MikeH]

Yes.
It changed with the '79 Mustang 2.8 to a rear sump.

 

[socorob]

Does anyone happen to have a front sump pan thats willing to share some measurements?

 

[pcmenten]

Sure. What's up, Rob?

 

[socorob]

Could you give me the measurements if the oil pan was on the ground upside down.
1.From the ground to the highest part(low side)
2. Ground to lowest part (short side)
3. From the very back edge of the lip to where it goes from shallow to deep, where the curve starts and the vertical part
4. From the very back edge of the lip to the front vertical part of the deep part of the pan

Thanks for any info you could give me.

 

[pcmenten]

Robbie, sorry for the delay. Today was yet another 10+ hour day at work. Just got home, so I'll change clothes and get right on that.

 

[pcmenten]

Could you give me the measurements if the oil pan was on the ground upside down.
1.From the ground to the highest part(low side)

4 3/8"

2. Ground to lowest part (short side)

3 3/8"

3. From the very back edge of the lip to where it goes from shallow to deep, where the curve starts and the vertical part

9", 11"

4. From the very back edge of the lip to the front vertical part of the deep part of the pan

19"

Note that for 3 and 4 I measured from the outer edge of the pan rail. The width of the pan rail is 5/8".

Thanks for any info you could give me.

Is that close enough?

Paul

 

[socorob]

Thanks! That helps a lot.