ITG Megaflow Filter for Dual Webers

[dla248]

ITG Megaflow Filter JC50-65, used one race as set up on Carl Christiansen's vintage race car. Please see ebay

http://cgi.ebay.com/ebaymotors/ITG-...r_Truck_Parts_Accessories&hash=item4aa6c1f7fd

Thanks

 

[RootesRacer]

ITG Megaflow Filter JC50-65, used one race as set up on Carl Christiansen's vintage race car. Please see ebay

http://cgi.ebay.com/ebaymotors/ITG-...r_Truck_Parts_Accessories&hash=item4aa6c1f7fd

Thanks

Its certainly nice, but unless you have the exact carb to carb spacing for the intake it was designed for, its not particularly useful.

Since Carl was involved, I have to assume that it was built for the TWM L-0077 sunbeam twin DCOE intake he once sold. If you can verify this, you may make mention of it, then perhaps you will sell it.

HTH

 

[dla248]

Intake manifold has MR 2020 stamped on casting. Replacement base plates are available from Coast Fabrication. Also I can supply dimensions if interested.

Thanks

 

[RootesRacer]

Intake manifold has MR 2020 stamped on casting. Replacement base plates are available from Coast Fabrication. Also I can supply dimensions if interested.

Thanks

Ive never seen that intake before.

Its not the L-0077 intake I figured it would be.

 

[mototron]

Hello
I would like to know the dimensions ?
center to center holes between carbs
Thanks
Rocco

 

[dla248]

Hi

I need to clarify, my setup uses an intake manifold for a right hand drive application. Maybe the other manifolds Carl marketed were for left hand drive. The base plate for the filter I have is not new and is cracked, but useable. The distance in the centers of the two inside trumpet is approx 3.750". The distance of the solid base plate between the Webers is 1.794". New base plates are available from Coast Fabrication.


manifold pic at:
http://rides.webshots.com/photo/2416884380106783585VQxGUe

Thanks
Dave Anderson

 

[alpine_64]

Hi

I need to clarify, my setup uses an intake manifold for a right hand drive application. Maybe the other manifolds Carl marketed were for left hand drive. The base plate for the filter I have is not new and is cracked, but useable. The distance in the centers of the two inside trumpet is approx 3.750". The distance of the solid base plate between the Webers is 1.794". New base plates are available from Coast Fabrication.


manifold pic at:
http://rides.webshots.com/photo/2416884380106783585VQxGUe

Thanks
Dave Anderson

I am quite sure i have one of these manifolds, they wont work for LHD as they are almost straight and interfeer with the streering box IIRC. Even on RHD this manifold requires you to run short stacks as it brings the velocity stacks close to the inner wheel arch.

 

[RootesRacer]

Hi

I need to clarify, my setup uses an intake manifold for a right hand drive application. Maybe the other manifolds Carl marketed were for left hand drive. The base plate for the filter I have is not new and is cracked, but useable. The distance in the centers of the two inside trumpet is approx 3.750". The distance of the solid base plate between the Webers is 1.794". New base plates are available from Coast Fabrication.


manifold pic at:
http://rides.webshots.com/photo/2416884380106783585VQxGUe

Thanks
Dave Anderson

Yeah, without that exact manifold (or manifold spacing) only the filter would be useful. I'd keep it with that intake if I were you, it adds to its value and anyone who buys your setup is going to be disappointed if it doesnt fit their carbs.