7 1/2 inch pressure plate

[mikefuller2]

I am looking for a 7 1/2 inch pressure plate for Alpine IV.
i have found out that they are hard to find. Can anyone help me
Thanks
Mike

 

[RootesRacer]

I am looking for a 7 1/2 inch pressure plate for Alpine IV.
i have found out that they are hard to find. Can anyone help me
Thanks
Mike

Really?

Have you tried the usual sources?

They show up on ebay all the time.


Oh, and a SIV should be an 8 inch shouldnt it?

 

[65beam]

pressure plate

series 4 cars with full syncro trans had 7 1/2 in clutchs in them.

 

[Cactusmasher]

7 1/2 inch pressure plate and discs

Mike: I have two 7 1/2 inch clutch discs, one brand new and one slightly used. I also have a 7 1/2 inch pressure plate, used, but in very good condition. I am in process of converting to V6-five speed-8 inch Ford rearend and will not be using any of the 7 1/2 inch pieces, so they are available to you. Make me an offer I can't refuse. Figure shipping weight at 15 pounds from Phoenix AZ to your location.

Jim Dimond

 

[RootesRacer]

keep in mind the 10 spine, 25 spline issue.

 

[Cactusmasher]

7 1/2 inch pressure plate and discs

Both discs are of the 10 spline variety.

 

[Jim E]

Arn't late pressure plates and fuel pumps NLA

 

[65beam]

pressure plate

there are 10 spline and 25 spline 7 1/2 inch clutches. the late seres 5 cars changed over to the 25 spline and continued on thru the fastback range. they used the same pressure plate on the alpine . the pressure plate for the fastback is different. sunbeam specialties still shows the pressure plate at a cost of 85.00.

 

[mikefuller2]

Pressure plate

Thanks Everyone
I have tried both Sunbeam Specialists and classic sunbeam and both have told me they don't have one.
Mike

 

[gpjn]

7 1/2 pressure plate

Hi Mark i have a 7 1/2 inch pressure plate used.it has no splines in the center?

 

[mikefuller2]

Thanks

thanks everyone I did find one from Jim Dimond and it is on its way
mike