1. Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.


    Dismiss Notice

Tiger Sway Bar Diameter

Discussion in 'Sunbeam Tiger' started by tylerite3124, Sep 7, 2021.

  1. tylerite3124

    tylerite3124 Platinum Level Sponsor

    What is the diameter of the Tiger sway bar as installed at the factory? Thanks for any expertise!

  2. Barry

    Barry Platinum Level Sponsor

    7/8" for the Tiger versus 3/4" for the Series Alpine.
  3. tylerite3124

    tylerite3124 Platinum Level Sponsor

    Thanks Barry.

    PROCRAFT Donation Time

    Make A 1"
  5. Bill Blue

    Bill Blue Platinum Level Sponsor

    Don't forget the mounts!.

    PROCRAFT Donation Time

    Buy them from Auto Zone or Energy or Pro Thane ..............
  7. Bill Blue

    Bill Blue Platinum Level Sponsor

    Can you buy a 1" bushing that will fit into the Alpine sway bar mounts? Never tried it, but I've always read the answer is "No". Or are you saying you can buy the 1" mounts at Auto Zone?
  8. RootesRooter

    RootesRooter Platinum Level Sponsor

    A 1" bar won't fit into Alpine/Tiger sway bar mounts.
  9. Toyanvil

    Toyanvil Gold Level Sponsor

    My series 2 came with a 5/8" sway bar stock and I always thought the Tiger was a 3/4" stock. I am running a 7/8" up front and 5/8" in the back on my series 2, and it works great.
  10. tylerite3124

    tylerite3124 Platinum Level Sponsor

    Thanks for your input. Much appreciated.
  11. Warren

    Warren Bronze Level Sponsor

    Pretty nice sway bar on the parts table at SUNI
    Somewhat smaller than the ADDCO one I had on Tiger's .

Share This Page