• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Series II - Fuel Pump w/Hand Primer

1

1962300

Bronze Level Sponsor
I am replacing my old filthy fuel pump.
It is so old & original it has the Hand Primer Lever as a part of it.

Should I toss it?
Should I hold onto it for posterity?
Should I sell it for cheap, cheap, cheap?
Thoughts?

Thanks!
 
Hand lever for priming is good. Does it not work? I like to always hold on to parts. Worst case you might help out someone else in the future.
 
It worked last time the car ran; about 8 years ago.
I'm rebuilding the engine & like to rebuild / replace everything inside & out of a motor.
So I ordered a new pump....not being aware of the hand level part of these factory pumps.
Otherwise I would have sent this one out to rebuild.
But I already mounted the new one.
Thanks
 

Attachments

  • Fuel Pump.jpeg
    Fuel Pump.jpeg
    1.6 MB · Views: 8
Better to clean it and flush the old gas from it., then store it away for a time you will need it the replace the "new" pump that most likely will not last as long as the "old one"......
 
You must log in or register to reply here.
Back
Top