• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Crankshaft thrust washers....

K

Ktapply

Donation Time
Can one of our resident experts confirm that the copper colored face, the same side as the relief, presumaby for oil passage...of the thrust washer faces the milled surface of the crankshaft?

Thanks

-Kevin
 
R

RootesRacer

Donation Time
Yes, the copper side (with oil relief slots) goes to the crank thrust faces.

To be sure its the correct bearing, be sure to measure clearances while you are at that point. This is best done with a dial indicator as it is tough getting an accurate figure with a feeler gauge.
 
You must log in or register to reply here.
Top