• There's still time to register for the SAOCA 25th Anniversary Invasion

    Let's go back to our Rootes – Dayton, Ohio
    July 30–August 2
    DoubleTree by Hilton Dayton Fairborn

    For details and to let us know you're coming, visit this thread.

    Cars | Fellowship | Fun | 25 Years of Memories

  • Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Anyone have or making the Tiger rear axle lowering blocks,

1/2" will be a bit of a challenge, because of

the locating pin(s).

Not just a "throw them in and go"

The locating pin on the spring will

not go through the lowing block

and make it to the axle housing.

a longer pin is needed.

And most likely, longer U-bolts.

Thicker lowering blocks are easier.

DW
 
Last edited:
You must log in or register to reply here.
Back
Top