• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

V6 conversion bell housing

Floor guy

Donation Time
How do you remove the clutch fork and actuator shaft from the bell housing. It is an internal fork assembly I will be going with a different throwout bearing setup.
 

DanR

Diamond Level Sponsor
Steve, I had several with tapered pins and with nuts.

Spoke with floor guy (Bill) a bit ago. Pulled a Bellhousing off the shelf so I could see for sure what was there. Would you believe there were two "split pins" holding the assembly together? First time I have seen that....
 

Rockonp04

Donation Time
How do you remove the clutch fork and actuator shaft from the bell housing. It is an internal fork assembly I will be going with a different throwout bearing setup.
There are two pins. You can see them in this picture. You might have to drill them out.
 

Attachments

  • 66508974603__B3CE6534-4A44-412A-85F2-0250E72FA569.JPG
    66508974603__B3CE6534-4A44-412A-85F2-0250E72FA569.JPG
    392.7 KB · Views: 24
Top