T5 with a 1725 motor

[JR66]

My Series V input shaft OD measures 0.6245. Full disclosure: measured with Harbor Freight 6" digital caliper.

 

[DanR]

The Alpine pilot bearing/bushing has nominal dimensions of:

OD .875"
ID .625"

I can confirm to the best of my ability the above is correct.

I went through four Alpine tranny's yesterday, all were the same.

 

[spmdr]

Ford V8/V6 T5s have a nominal .668 input shaft tip for the pilot bearing.

DW

 

[MikeH]

https://www.stangnet.com/mustang-forums/threads/good-gear-ratio-for-t5-transmission.905568/

scroll down through the posts. There is a chart of specs

 

[spmdr]

Here is a link to some T5 info I tend to forget about because the site is stagnate

And the Link may go dead at any time.

But it does have some clear 5th gear numbers.

DW

http://www.tigersunited.com/techtips/WaltersT5/pt-WaltersT51.asp

Note, I have NOT seen a T5 page web info that is 100% correct, or complete!

An example, In the Stangnet link, the ratios of a #251 trans does NOT have a .68 5th gear.

Also, in the Tigers United T5 info, I never put a #253 trans in a Tiger, the number should

be #251....

 

[MikeH]

Here is another site of T5 info.
http://www.britishv8.org/Articles/Borg-Warner-T5-ID-Tags.htm