• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

Need Weber aux. venturis

M

mbrianrobinson

Donation Time
I need two aux venturi's for a 40DCOE, the kind where the air horn slides down around the venturi. They need to have a 4.5 size marking on them. Any help out there?
 
M

mbrianrobinson

Donation Time
I am not familiar with those terms. The venturis that I need have been machined at the top (if the carb were standing on it's base) edge so that there is a small annular area between the venturi and the carb body into which slides the air horn.

I have attached a photo of one of these type of venturi's. Notice on the left end the outside is smooth, around this area the air horn slides. The other type of venturi has a ridge at this end to center the venturi in the carb body.
 
You must log in or register to reply here.
Top