Heater/vent question

[sunny67]

Does anyone have pictures of their under dash heater and vent installation? The PO removed everything and blocked the holes. I’m trying to reinstall. I believe I know where all the components in the picture go but conformation pictures would help. I particularly need to know where all the control cables and rods go as well as the ducting route for the defrost. This is an 1967 S5 left hand drive.

 

[hartmandm]

I have a bunch of photos of my series 5 in the Gallery. A few under dash photos are those photos.

Start looking at https://forum.sunbeamalpine.org/index.php?media/albums/mike-hartmans-series-v-restoration.12/page-3

Decent shot here (the left demister hose is absent): https://forum.sunbeamalpine.org/index.php?media/20150111-001-orig-speedo-cable.2869/

I can take some more photos if needed.

Mike

 

[DanR]

Take special attention to the fresh air boxes, they are right and left handed....

Classic Suneam and Sunbeam Specialties have repair kits available.

 

[alpine_64]

It's also worth adding a fine mesh atop the fresh air boxes to stop debris falling down inside and blocking the drain tubes.

 

[Pete S.]

Does anyone have pictures of their under dash heater and vent installation? The PO removed everything and blocked the holes. I’m trying to reinstall. I believe I know where all the components in the picture go but conformation pictures would help. I particularly need to know where all the control cables and rods go as well as the ducting route for the defrost. This is an 1967 S5 left hand drive.

These are from a Tiger 1, but you might find them useful.

 

[sunny67]

Thanks everyone. This is a big help.