• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

2.8 v6 Waterpump question

birdfan56

birdfan56

Platinum Level Sponsor
I'm sure it's been answered before but i cannot locate the answer. What size bolts are used on the water pump housing? The perimeter ones are all the same size but there are a couple inner ones that are different. Does anyone have the answer? Thanks so much, Kevin
 
DanR

DanR

Diamond Level Sponsor
Kevin, just saw this...

In addition to those, takes 2 bolts 8mm 1.25 thread 75mm length.
 
DanR

DanR

Diamond Level Sponsor
Remember the three that secure the thermostat housing are two different lenghts also. Special note: Do not over tighten them because the rear by pass housing is aluminum and the threads strip easily.
 
You must log in or register to reply here.
Top