Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.
If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.
Enjoy.
That has to be the worst timing gear I have ever seenI wanted to update on this as things were not as good I a thought in my last post. I thought I had fixed it when I managed to get the car running. It ran for 10 minutes and then back to the old tricks. I kept setting TDC and then the distributor, and switched rotors, caps, distributors, plugs, wires, etc.. trying to get this car to run. Occasionally it would cough and sputter, but generally not. The long story short is this. Its was literally jumping multiple teeth on the crank sprocket every few starts or under any aggressive load, at which point it would not run. I would occasionally get lucky every 20 attempts at starting it, and I think I set the engine to TDC 40 times. Started to see things like the rotor being in such a different location and then noticing the valves not being in the right position, or the engine would fire but have no compression or backfire through the manifold and carbs. Then I would reset to TDC and try again. I rotated that engine 100 miles I think. When I finally dug into the timing case it was sooooo painfully obvious. Even trying to loosen the cam gear caused the chain to slip. The chain was stretched just a bit, but the crank gear was completely shot.
Still don't get how the tensioners look and feel brand new after 50+ years. I had ordered a bunch of stuff from Rick not quite knowing what I might find when I got into it, and other than the new chain and crank sprocket, I used all the old stuff as it looked great. With the new chain and gear in place, the car literally fired up and ran like it should first crank, and has continued to do so. Even took it for a short spin when the weather cleared.
Just wanted to get this here for others so they don't stupidly torment themselves for as long as I did.
Thanks again for all the great advice and support. Heres a picture of "toothless" my old gear next to the fresh one. Quite a difference.
Mark B
Yep! ... probably sittin' in the pan waiting to reak havoc!I would worry about where all that loose metal is inside the engine.