• Welcome to the new SAOCA website. Already a member? Simply click Log In/Sign Up up and to the right and use your same username and password from the old site. If you've forgotten your password, please send an email to membership@sunbeamalpine.org for assistance.

    If you're new here, click Log In/Sign Up and enter your information. We'll approve your account as quickly as possible, typically in about 24 hours. If it takes longer, you were probably caught in our spam/scam filter.

    Enjoy.

ALTERNATOR

DanR

DanR

Diamond Level Sponsor
Joel, What are the measurements for the mount? Or better yet what part number?
 
P

PROCRAFT

Donation Time
400-52062 from mount to mount 5.5" center /pulley to back of case 5.25 this is as said a clone just like you'd find at Nissan etc.
I've used these for years. Joe Parlenti just did an article in the Rootes Review on this also.
 
Last edited:
P

PROCRAFT

Donation Time
Series6 said:
Might want to save that Joel. Might need it soon.
Click to expand...
Ok, when I bought the one I'm using was supposed to be single wire NOT! So they sent this to replace problem is the shaft diameter is smaller for a V belt as opposed to a 6 rib serpintine so it's surplus!
 
phyrman

phyrman

SAOCA Secretary
Diamond Level Sponsor
I have the 35 amp version on my V6 DanR, this is were I needed to put the 1/4" spacers with your alt bracket
Mine is off a fork lift
BD
 
You must log in or register to reply here.
Top