I was contacted via our Facebook page by a SII owner looking for a 'hockey stick' door finisher. While they turn up periodically - a pretty rough set was just sold on eBay - I know these are generally in the unobtainium category. Still, I encouraged the owner to join the club and post on the Wanted forum. At the same time, this got me thinking. While I know next to nothing about 3D printing, this would seem like a pretty good candidate to me. Do any of our members have experience and access to the equipment? I know we could source a good one to scan and imagine it is pretty simple to electronically flip the scan to be able to make both sides. There probably aren't enough SII's out there to make this commercially viable, but it might be a need the Club could fill.